3D Scanner Year 2 Project Week 2

This week the group received the components required and began to build the scanner. The lifting part of the scanner was successfully assembled.
The motor was set to rotate and pause for certain time in clockwise direction and installed in the base. It was connected and fixed with the thread rod by a shaft coupler. Then two linear shafts were installed on the base and the carriage was zipped with bearing. The group tested the lifting components and the gif shows the details.
 
The motor was set to rotate in counterclockwise direction and the carriage began to descend.
The plan for week 3 is installing the IR sensor, rotatable plate and the motor synchronized with lifting components.

Comments

Post a Comment

Popular posts from this blog

3D Scanner Year 2 Project Week 5

Image
This week the group finished the final assembling and testing process and put the electronic components into a wooden case. The whole device and a short video of scanning progress is shown below. The 3D Scanner   However, there are some distance and size limits. Since the width of the object is too small, the sensor did not receive the accurate data and the simulation results are shown below. The members is still trying to optimize the code and adjust the components at the final moment. Soon, everyone will be ready for the bench inspection. Here is the poster：
Read more

3D Scanner Year 2 Project Week 3

Image
This week the group tried to make two motors work together and install IR sensor. Firstly, the group tried to set the motor for rotatable plate (named motor A) to work at a certain angular velocity while the motor for lifting (named motor B) to raise the carriage when the plate turns a circle. After the discussion with AA, the group decided to make motor B work at a much slower velocity than motor A so that the IR sensor can obtain a more accurate and consecutive data which is shown below. Then the group attempt to install the IR sensor and set the voltage-distance relationship equation in Arduino showed below. Also the group intended to initialize the SD card for data storing as shown below.   Unfortunately, the group found IR sensor and SD card shield out of function after a series of tests. The group plan to replace the malfunctioning components and finish the building process next week.
Read more